User manual

73
Change the Fuses
Change the Fuses
Introduction
The Océ BLM500 has two fuses at the mains power input. If either fuse is broken,
the Océ BLM500 will not operate.
Attention: Turn OFF the machine and remove the mains power supply cable
before you change the fuses. This machine uses two fuses in parallel.
Fuse Description
- 7A, HRC Quick acting, F
- Article number 1060059289
Procedure
1. Turn OFF the Océ BLM500.
2. Disconnect the Océ BLM500 from the mains power supply.
3. Turn one fuse-holder to the left and remove the fuse-holder from the Océ BLM500
4. Check the fuse.
5. If the fuse is broken then replace with a fuse of the correct specification.
6. Repeat the procedure for the other fuse.
Note: If the fuse breaks again, then call your service engineer.