User manual

71
Clear a Stitch Head Jam
[43]
Step Action Information
1 "Lift the Océ BLM500
main deck.
Lift the Océ BLM500 Main Deck on
page 40
2 Remove the wire-holder
from the stitch head.
■ Move the wire-holder retaining
spring to the right. figure 35 on
page 69
■ Remove the wire-holder
If the wire-holder is held in position, use
a screw driver to help remove the
wire-holder from the stitch head.
[37]
3 Inspect the area behind the
wire-holder for
stitch-wire.
figure 36 on page 70
4 Remove any stitches or
pieces of stitch-wire and
clean the area with the
air-duster.
Use the wire-cutters to remove any
jammed stitches or pieces of stitch-wire.
5 Lubricate the stitch-head. Lubricate the Stitch Head on page 85
6 Fit the wire-holder. Remember to put the wire-holder
retaining spring in position.
7 Close the Océ BLM500.
8 Start the Océ BLM500. If the head operates normally and returns
to the parked position, then further action
is not needed.
If the stitch-head remains jammed, then
repeat the procedure once.
If the problem continues, then contact
your service engineer.