User manual

68 Chapter 5 Error Conditions, Problems and Solutions

Clear a Stitch Wire Jam

Before You Begin

[39]

Clear the Jammed Wire

[40]

Step Action Information

1 Turn off the BLM500 Use the mains ON/OFF switch.

2 Disconnect the BLM500 from the

mains power supply.

3 Lift the BLM500 main deck (see ‘Lift the Océ BLM500 Main

Deck’ on page 40)

Step Action Information

1 Cut the stitch wire at position

'A' approximately 50mm

(2-inches) from where the

stitch wire leaves the

stitch-wire guide.

[32]

Detail A: Cut stitch wire here.

2 Cut the stitch wire at position

'B' between the feed gears

and the middle wire tube.

[33]

Detail B: Cut stitch wire here.

3 Pull the stitch wire from the

stitch wire guide block.

[34]

Pull stitch wire in direction of arrow

4 Pull the stitch wire from the

middle wire tube.

Stitch Head.. If there is not enough

stitch-wire left to pull, then follow the

procedure(see ‘Remove the Stitch

Wire from the Stitch Head’ on

page 91)

5 Install the stitch wire into the

stitch head.

(see ‘Install the Stitch Wire into the

Stitch Head’ on page 93)