User manual

66 Chapter 5 Error Conditions, Problems and Solutions
Stitch Head Problems
Stitch Head Problems
[37]
Problem Cause Solution
The stitch head does not
operate
The STITCH function is
not selected.
Make sure STITCH is set to 1 or
more (see ‘The BASIC Window’ on
page 26).
The stitch wire is
finished.
Load a new spool of stitch-wire (see
‘Install New Stitch Wire’ on
page 90).
The stitch wire is
jammed.
Clear the jammed stitch wire (see
‘Clear a Stitch Wire Jam’ on
page 67).
The stitches are broken There is stitch wire
jammed in the stitch head.
Inspect and remove the jammed
stitch wire (see ‘Clear a Stitch Wire
Jam’ on page 67).
The stitch wire is jammed
on the spool
The stitch wire spool is
not installed correctly.
Check and correct (see ‘Fit a New
Stitch Wire Spool’ on page 91).