User manual

58 Chapter 5 Error Conditions, Problems and Solutions
Book Quality
Spine Form Problems
[29]
The stitch is not on the
center line of the spine
The wrong paper size
was entered on the
touch screen.
Measure the paper and enter the
correct dimensions.
The Océ BLM500
adjustment system is
not calibrated
correctly.
Touch RE-REF in the
ADVANCED window to
calibrate the Océ BLM500
adjustment axes. (see table 12
on page 30)
The books do not stack
on the stacker
The collection table is
in the wrong position.
Adjust the position of the
collection table to fit the size of
the finished book. (see ‘Adjust
the Gate in the Gathering Area’
on page 44)
The book cover is dirty
or marked
The former roller is
dirty.
Clean the former roller (see
‘Clean the Former Roller’ on
page 82).
The former clamp is
dirty.
Clean the Polyurethane Strips
in the Form Clamp on page 83
Book Quality
Problem
Cause Solution
Spine Form Condition Solution
[21]
Correct
The spine is square at
each end and the paper is
not damaged.
The Océ BLM500 setting
is correct. Adjustment is
not needed.