User manual

51
Error Messages
Error Messages
[27]
Problem Cause Solution
AXES MOVING Some of the machine axes are
moving. This message clears
when the adjustment is
complete.
BOOK CYCLE TIME
TOO LONG
The printer has delivered the sets
faster than the books can be
made. To decrease the book
cycle time, adjust the machine
settings:
■ decrease the number of
FORMS
■ decrease the number of
STITCHES
■ decrease the TAMPER
TIME
Bridge axis moving The bridge axis is moving. This
message clears when the
adjustment is complete.
BRIDGE INFEED
COVER OPEN
The bridge infeed cover is open.
The machine will not operate
until the cover is closed.
(see ‘Clear Paper
Jams’ on page 60)
BRIDGE MOTOR
STALL
Check for a paper jam in the
connecting bridge. Clear the jam
and continue.
(see ‘Clear Paper
Jams’ on page 60)
CHECK THE TRIM
BIN
The trim bin is either open or
full. Check the trim bin. Empty
the trim bin if necessary.
COVER OPEN A safety cover is open. The
machine will not operate until
the cover is closed.
DRIVE MOTOR
STALL
There is a paper jam. Check the
machine and correct the error.
Endlay axis moving The endlay axis (size
adjustment) is moving. This
message clears when the
adjustment is complete.