User manual

44 Chapter 4 Standard Tasks
Adjust the Gate in the Gathering Area
Adjust the Gate in the Gathering Area
Introduction
The gate in the gathering area must be in the 'up' position for jobs of 1 to 3 sheets
and in the 'down' position for jobs of more than 3 sheets. If the gate is left 'down' for
thin jobs, then the sheets of paper can be damaged or jam in the machine.
[20]
[20] Gate in the 'up' position
[25]
When to do
■ When you start a new job
Lift the Gate in the Gathering Area
1. Open the gathering area cover. Open the Gathering Area Cover on page 39.
2. Lift the gate on the sidelay until the gate engages with the metal spring-clip.figure 20
3. Close the gathering area.
Lower the Gate in the gathering Area
1. Open the gathering area cover. Open the Gathering Area Cover on page 39
2. Press on the gate to disengage the gate from the metal spring-clip.figure 20
3. Close the gathering area.
B
C
A
AMetal Spring Clip
BGate
C Sidelay