User manual

14 Chapter 2 How to run the Océ BLM500
Enter the Job Settings
Enter the Job Settings
Introduction
Make the settings for a new job in the BASIC window on the touch screen. See
'The User Interface' on page 11 for more information.
The PAPER SIZE and PAGE DIRECTION settings are entered via the touch screen.
These dimensions refer to the format of the paper when it enters the Océ BLM500
Attention: Do not operate the touch screen with a sharp object or with too much
force. These actions can damage the touch screen.
Before You Begin
1. Print a set to the stacker.
2. Measure the sheet size and the set thickness.
3. Use these dimensions for the job setting.
Note: This set can be made into a book. See Operate the Océ BLM500 offline on
page 45
[4]
[4] Kind of print jobs
If the Print Job is then follow this procedure
a standard paper size See Job Setting for a Standard Paper Size
not a standard paper size See Job Setting for a Non-Standard Paper Size
a saved job See Job Setting for a Saved Job on page 16