Specifications

64
64
(continued on next page)

pR o b l e m pR o b a b l e C a U s e s so l U t I o n s
Entire spa is inoperative
• Powerfailure/notpluggedin • GFCItripped • Heaterhigh-limitthermostattrippe
• Checkpowersource • ResetGFCI;callforserviceifitwillnotreset • Disconnectpowerforatleastthirtysecondstoresetheaterhighlimit.
If it will not reset, check for clogged filters. If tripping continues, call for service.
Spa jets and heat off, light operates (Display reads _ . _ . _ . _
)
• Pressureswitchisopenwhenjetsareon
and should be closed.
• Checkforcloggedfilter.Thepressureswitchwillresetwhentheflow
of water through the heater has been restored. Call for service if the pressure switch trips frequently
(Display reads
_ _ _ _
)
Pressure switch senses flow through heater
even though the jet pump is off
Contact an Authorized Service Technician
READY icon flashes
• ControlSensoropenorshorted • ContactanAuthorizedServiceTechnician
Jets weak or surging
• Spawaterleveltoolow • Filtersclogged/Jetintakescreensclogged • Jetnozzlesclosed/Airvalveclosed
• Addwater • Cleanfilters/Cleanjetintakescreens • Openjetnozzles/Openairvalve
Light inoperative
• Spalockactivated • Lightwiringorassemblyisfaulty
• Deactivatespalock • Replacelightassembly
.
Display reads - - - - (Entire spa inoperative)
• Heaterhigh-limitthermostattripped • Disconnectpowertothespaforatleastthirtysecondstoresettheheater
high-limit. If tripping continues, clean the filter, then if tripping still occurs, call for service.
.
Set water temperature significantly different from display temperature
• SystemControls • ContactanAuthorizedServiceTechnician
_ _ _ _
_ . _ . _ . _