Specifications

56
5656565656
5. Carefully loosen the long Tygon / Kynar tubing to the bottom of the ozonator. Aliquidsubstancemaybefoundinsidethetubing.
Ifaliquidsubstanceispresent,becertainnottocomeintocontactwiththeliquid(seewarningabove).
6. Place the end of the tubing into the vinegar, making certain that the end of the tubing sits at the bottom of the container. 7. Reconnect power to the spa. 8. Run the spa until all 16 ounces (half liter) of the vinegar are gone. This should allow an ample flow of vinegar to be run through the
injector and clear the blockage.
9. Disconnect power to the spa. 10. Remove the empty cup or bucket. 11. Reinstall the tubing to the bottom of the ozonator. 12. Plug the ozonator into the control box. 13. Close the equipment compartment door. 14. Reconnect power to the spa. IMPORTANT: When using the FreshWater
®
III high output ozone system, the circulation cycle must be activated to ensure
adequate ozone circulation. Refer to the circulation cycle in the HEATING AND HYDROMASSAGE SYSTEM section for more information.
do s a n d do n ’t s
•DON’Tuseswimmingpool(muriatic)acidtolowerpH. •DON’TsplashpHincreaseradditivesonthesiding. •DON’TuseCompressedSanitizers.
The use of bromine sticks or tablets in floaters, which may become entrapped in a lounge or cooling seat (or sink to the spa floor), have been shown to cause discoloration of or surface distress to a spa’s shell.
•DON’Tuseafloatertypesanitizationsystemasalowornomaintenancesolutiontoyourspamaintenanceprogram.
The spa shell easily can withstand the effects of a properly administered sanitizer. Floating dispensers can become trapped in one area and cause an over-sanitization (or chemical burn) of that particular area.