Specifications

4141414141
Drain your spa following the Draining Your Spa section in the owner’s manual. 1. Remove the filter cartridge, clean and store in a dry place.2.
IMPORTANT: These additional instructions must be utilized when draining and winterizing your spa in climates where the temperature falls below 32°F (0°C). A five (5) gallon combination (vacuum/blower) wet/dry shop vac must be used to effectively remove water that is trapped inside the plumbing lines.
Attach the vacuum’s hose to the blower side of the shop vac.3.
a) Place the end of the vacuum hose down the filter opening. b) Turn on the blower function and allow it to blow out any water remaining in the plumbing lines (approximately 3 to 5 minutes).
Attach the vacuum hose to the vacuum side of the shop vac. Vacuum all openings and orifices as follows:4.
a) Jet openings: start with the jets at the top and move downward (if suction is coming from another jet, block off the other jet usingalargerag–thiswillhelppulloutthewaterthatistrappeddeeperinsidethemainline). b) Filter suction fittings and filter compartment. c) Main drain outlet (it may be necessary to cover the drain grate tightly with a rag when vacuuming the main drain to ensure water is drawn completely from the internal plumbing system).
Thoroughly dry the spa shell with a clean towel.5. Replace the main drain cap.6.
CAUTION: Use only Propylene Glycol as your anti-freeze. This is non-toxic. Never use an automobile anti-freeze (Ethylene Glycol) since it is toxic!
Using a long-extension funnel, pour anti-freeze into all standpipes, filter suction fittings, and jet orifices. Add enough anti-freeze 7.
toensureadequateprotection–inmanycases,youwillseetheliquidintheorifice,orcomingoutofanotherlocation.
Close the spa cover and fasten the cover tie downs. Cover the spa cover with two pieces of plywood to evenly distribute the 8.
weight of snow and ice. Secure a plastic sheet, or tarp, over the spa cover and plywood.
Replace the equipment access door, if removed.9.
Opening Instructions:
Remove plywood and plastic sheet. Open the spa cover by unfastening the cover tie downs.1.