Specifications
30
30303030
SERVICE NOTE: A slow or non-moving Moto-Massage jet may indicate that the filter cartridge pores are obstructed with dirt, body
oils, or calcification. Follow the filter cartridge cleaning procedures in the Spa Care and Maintenance section of this manual.
ACCESSORY NOTE: For a different-feeling massage, ask your dealer about the HydroPulse
®
option, an alternative faceplate for your
Moto-Massage jet.
hy d r o m a s s a g e je t s
A. On the TX spa, the hydromassage jet features a dual-port rotary nozzle while on the SX both directional and dual-port rotary
nozzles are used. The intensity of this jet is determined by the volume of air which is introduced into the jet chambers, where it
mixes with the water stream. The Comfort Control
®
lever is used to change the intensity of this jet. The jet is also individually
adjustable;simplyturnthefaceplateclockwisetodecreasethejetpressureorcounterclockwisetoincreasethejetpressure.
ACCESSORY NOTE: Ask your Solana Spa Dealer about Rotary or Directional Hydromassage Jet Kits, which can be installed easily
in your spa in place of the directional or rotary nozzle to vary the effect of the jet.
The nozzles can be removed by grasping the nozzle and gently pulling away from the jet faceplate. To install a new nozzle, align the
four prongs on the rear of the nozzle with the four holes in the interior of the jet faceplate and press the nozzle into place. The nozzle
will snap into place.
Pr e c i s i o n
®
je t s
Precision
®
Jets are designed to perform a soft, soothing massage on your back and shoulders. Adjust their pressure using the Comfort
Control lever.
SAFETY EQUIPMENT
A. GFCI: The Ground Fault Circuit Interrupter, located on the end of the power cord, is a safety device that is designed to sense as little
as 5 milliamps of electrical current leakage to ground. It is very important to protect a GFCI from rain and other moisture. Watkins
Manufacturing Corporation recommends that the GFCI be tested before each use to ensure it is functioning correctly.