Specifications

ManualsBrandsWatkins ManualsHome building and DecorSolana

28282828

the filter Icon will blink for the remaining filter cycle time. Should the temperature cool down to 1.5 degrees F

below the set point before the end of the cycle, the cycle will resume for the rest of the time. Should you use the

spa during the filter cycle by placing the jet pump on high-speed, the Filter Icon will blink. Once the jet pump has

been shut off, a ten minute tranquil mode begins (FILTER Icon will be blinking during tranquil mode) before the

filter cycle will resume. The blinking filter Icon indicates that the filter cycle timer is still counting, but the cycle has

been temporarily interrupted.

NOTE: The interrupted time of a filter cycle is not extended after the filter cycle resumes. Power interruptions of the spa will reset the

filter cycle to the default cycle time and begin 10 minutes after spa regains power

cl e a n cy c l e

The Clean Cycle has been provided as a convenient timer for water maintenance. When the Clean Cycle is

initiated, the jet pump will activate in high speed. The jet pump symbol will flash on and off until the cleaning

cycle is complete. The total cleaning cycle time is ten minutes. If the clean cycle does not engage, make sure the

SPA LOCK is deactivated. To activate the Clean Cycle, Press the SET button followed by the JETS button.

sl e e P mo d e

The Sleep Mode operation is a feature that minimizes pump operation during quiet evening hours. For example,

if Filter Cycle 1 is set to activate at 8:00 a.m., by default Filter Cycle 2 will be set to activate at 8:00 p.m. (12 hours

later). During 8:00 p.m. to 8:00 a.m., if the spa should call for heat, the pump and heater will activate to heat the spa

under normal temperature demand. However, when in Sleep Mode, should the spa call for heat, the pump and

heater will be suspended after Filter Cycle 2 until the activation of Filter Cycle 1, at 8:00 a.m. to minimize pump

activation during quiet evening hours.

Important: Power-up of the spa starts the F1 default sequence. In order for the Sleep Mode to work in the evening hours, the spa

must be powered up in the early morning hours. The Sleep Mode will always be active the 6-12 hours between the end of (F2) and the

begining of (F1) depending on how the filter cycle program is set.

Note: if temperature drops below 80 degrees, heater will automatically activate to prevent spa from freezing.

To activate Sleep Mode feature, press and hold Temp Up (

▲

) & Temp Down (

▼

) buttons together for 3 seconds. This will activate the

feature and override the normal temperature demand. When these buttons have been engaged, a Moon & Stars icon (Sleep Icon) will

appear in the display of the control panel, indicating this feature has been activated. To deactivate this feature, simply press and hold

SET

READY

SET

READY

SET

READY

SET

READY

SET

READY

SET

READY

SET

READY

SET

READY

SET

READY