Specifications

the rounded side, until a level reading is achieved. These are now your preselected shims.

4. Carefully remove the carpenter’s level and the sets of shims. With one or more persons lifting the lowest side of the spa, place

a 4” x 4” (10-cm x 10 cm) block under the spa base, in the center of the side lifted.

5. Set the preselected shim sets under the wooden base support at each

shimming point, as shown. Lift the spa, remove the support block, and set

the spa on the shims. Repeat this procedure for the opposite side of the

spa, if necessary.

6. Use the carpenter’s level to recheck the level of the spa.

7. Identify the locations of any remaining shimming points using the

illustration below, and carefully slide helper shims under the spa beneath

each location. These helper shims should create a snug fit between the

foundation and base support system. If it is necessary to lift the spa to

place the helper shims, use care not to kick out the original corner shims.

121212

42" (106.7 cm)

3 1/2" (8.9 cm)

29" (74.0 cm)

33" (84.0 cm)

68 1/4" (173.4 cm)

72" (183 cm)

31 1/4" (79.4 cm)

18 1/2" (47 cm) 18 1/2" (47 cm)

72" (183 cm)

SX 10

15" (28.0 cm)

15 1/2" (39.4 cm)

28" (71.1 cm)

53" (134.6 cm)

20 1/4" (51.4 cm)

34 1/8" (86.7 cm)

SX Spa

