Specifications

your local city government office.

2. IMPORTANT: The spa is designed for installation on a relatively flat and level surface. Installing the spa on an unlevel surface will

result in unlevel water and an aesthetically unbalanced spa, and may affect its performance. The spa may be shimmed according

tothefollowingSpaLevelingInstructions;however,shimmingofthespamayplaceadditionalstressonthespa’ssupportsystem.

Damage to the spa caused by the incorrect installation of the spa is not covered by the warranty.

3. Place spa in the desired location and determine which one of the two exits will be used for your power cord (See illustration). A

notch on the bottom of one of the side panels must be selected as the exit location. Remove the front access panel to expose the

equipment, frame, plumbing and foam insulation. Unwind the power cord, located inside the equipment compartment. Work the

cord into the notch of the frame below the equipment compartment. Pull the cord following the contour of the spa in the direction

of the exit notch. Once you reach the side panel, remove the bottom screw in the side

panel, then tuck the cord behind the side panel until you reach the exit notch where

the cord should be seated. Do not plug the spa in until the spa is filled with water!

Replace side panel screw once cord is installed.

SPA LEVELING INSTRUCTIONS

Approved Shim Material 1/4” to 1/2” (0.5 cm to 1.5 cm) thick, cut into 2” x 4” (5 cm x 10 cm

rectangles):

•CedarShingles •ExteriorRatedPlywood •Redwood •ExteriorRatedLumber

su g g e s t e D le v e l i n g pr o c e D u r e :

1. Using a six-foot carpenter’s level (or a short level and a straight piece of wood about

eight feet long), check the spa to identify the lowest and highest corners.

2. With one end of the carpenter’s level resting on the highest corner of the spa, and the

opposite end resting on the lowest corner, gently raise the lower end of the level with

shims placed on the corner of the spa shell, until a level reading is achieved.

3. Carefully lift and pivot the carpenter’s level (so as not to knock over your stack of shims)

to the remaining corner. The TX spa may be shimmed under any of the dimple locations

shown in the bottom view of the spa. The SX spas may be shimmed under any of the

levelingpoints(•)foundonthenextpage.Placetherequirednumberofshimsundertheendofthelevelateachcornerandalong

111111

67"

16"

Shimming points

Possible

cord exits

- 5 Dimple locations in Base Pan

TX Spa