Specifications
9999
Deck InstallatIon
To be certain your deck can support your spa, you must know the deck’s maximum load capacity. Consult a qualified building contractor
or structural engineer. To find the weight of your spa, its contents and occupants, refer to the Spa Specifications. This weight per square
foot must not exceed the structure’s rated capacity, or serious structural damage could result.
OUTDOOR INSTALLATION
No matter where you install your new spa, it’s important that you have a solid foundation to support it. Structural damage to the spa
resulting from incorrect installation or placement on an inadequate foundation is not covered under the spa’s limited warranty.
If you install the spa outdoors, we recommend a reinforced concrete pad at least four inches thick. The reinforcing rod or mesh in the
pad should be attached to a bond wire.
If you place the spa on the ground, even temporarily, place stepping stones under the leveling areas (see Spa Leveling Instructions). The
stones should be at least two inches thick and twelve inches square. Even with stones in place, the spa will inevitably settle and become
unlevel.Plus,aspasurroundedbydirtorgrasswillsoonbefilledwithdirtorgrassfromusers’feet;therefore,itisimportanttogetit
onto a solid foundation as soon as possible.
HOW TO MOVE THE SOLANA
SPA
The Solana spa has been designed to be easy to move and install. For ease of handling, the spa should be moved as close as possible to
the installation site before unpackaging. NOTE: Take care not to damage the spa with unpacking tools.
NOTE: Before unpacking or moving the spa, verify that you have a clear pathway to its destination (measure if necessary).
CAUTION: Do not slide or roll the spa on its side. This will damage the siding.
REMOVAL AND REPLACEMENT OF THE FRONT ACCESS PANEL
(TX SPA)
Your TX spa uses three panels that are attached to the frame. These panels are referred to as side panels and a front panel. The front
panel is located below the control panel. Behind the front panel, you’ll find all the electrical components. The front panel is held onto the
frame with six Phillips screws.
re m o v a l o f t h e f r o n t a c c e s s p a n e l