Specifications

ACE Salt Water Sanitizing System Page 5
is low, or down if the chlorine level is high, to find the level that produces a stable
chlorine level of 3-5 ppm. This will help maintain water quality. Allow 24 hours for a
change in Use Level to register in the chlorine reading on a test strip.
Adjusting the Use Level will cause the value on the screen to flash. Once the 3.
correct Use Level is displayed, press the Confirm? soft button to enter your
selection. The value will stop flashing, and the “?” next to the word Confirm
will disappear.
Press the 4. BACK hard button to return to the main menu.
RECOMMENDED: Following initial start-up, test the chlorine level of your spa once a
week. Adjust the Use Level up if the chlorine level is low, or down if the chlorine level
is high, to find the level that produces a stable chlorine level of 3-5 ppm. This will
help maintain water quality.
STEP 4 – Set Spa Size
Determine the value (1-8) associated with your spa model using the Spa 1.
Model Table on page 4.
In the Water Care System menu, press the 2. Set-up soft button.
Press the 3. Spa Size soft button.
Adjust spa size using the soft buttons next to the arrows. 4.
Adjusting the Spa Size will cause the value on screen to flash. Once the 5.
correct Spa Size is displayed, press the Confirm? soft button to enter your
selection. The value will stop flashing, and the “?” next to the word Confirm
will disappear.
Once Spa Size has been selected, press 6. Confirm? soft button to enter your
selection.
Press the 7. BACK hard button to return to the main menu.
STEP 5 – Test for chlorine and establish residual
Once your spa is programmed, check the chlorine level with a FreshWater test 1.
strip. Depending on your spa model and water quality, it will take approximately
24 hours for the ACE system to generate enough sanitizer to establish a
chlorine residual of 3-5 ppm.
Granular sodium dichlor may be added as directed on the bottle to bring the 2.
spa water to 5ppm as described in the spa’s Owner’s Manual, to create a
sanitized residual until the ACE system is generating sanitizer at full capacity.
Allow jets to run 5 minutes per jet system (rotating the diverter valves).3.
NOTE: : Ensure that the Vanishing Act calcium remover is
repositioned after running jets