Specifications

ACE Salt Water Sanitizing System Page 9
Soak the cell for 10 minutes or until bubbles stop coming from the cell. If 5.
bubbles are still releasing from the cell after 10 minutes, change the
cleaning solution and repeat.
Replace cell into the filter standpipe. Screw on the gray filter cap, replace 6.
the filter lid, and power up the spa. Ensure that the cell is at the bottom of
the filter standpipe by feeling for the pull of the pump’s suction.
IQ 2020
®
Remote Control (Optional Accessory)
The IQ 2020 remote control has the same control capability as the spa’s main
control panel.
To access the ACE system menus, press the MODE button until 1. CHEM+
is displayed on the screen.
Press the (+) button to enter into the ACE system menus. The word 2. ADD
will appear on the screen.
Press the MODE button to scroll through the ACE system menus. 3.
To change a setting, find the desired menu, press the (+) button to enter 4.
that menu. Press the (+) again to change the setting. Press the (-) button
once to set a new setting, and a second time to confirm.
To exit the ACE system menus, press the MODE button until the 5. EXIT
screen is displayed. Press the (+) button to exit.
Tips
Vacation or limited use.• When the spa is not going to be in use, shock the
spa by increasing chlorine to 3-5 ppm and then run the automatic clean cycle.
Clean or replace filters. Lower Use Level setting to 1. For extended vacations,
also lower the Spa Size by 50%.
Water Changes.• Because the ACE salt water sanitizing system reduces the
amount of chemicals added to the spa water, it is possible to significantly
extend the life of the water. Test your water regularly to ensure safety.
If heavy bathing is expected.• Initiate a Boost a few hours prior.
Periodically measure the chlorine and add granular sodium dichlor as need.
MPS use.• Granular MPS (Potassium Peroxymonosulfate) can be used
in place of sodium dichlor to establish a sanitizer residual at start-up, and
for shocking the spa at each 30-day check up. Use FreshWater MPS test
strips to measure MPS levels in the spa water.
Mixed Oxidants.• To clean the water, the ACE salt water sanitizing system
generates a variety of mixed oxidants, in addition to chlorine. The chlorine
reading on the test strip may not be indicative of total oxidizer level.
Ozone.• The ACE salt water sanitizing system is safe to use with ozone;
however, except for in extremely high use situations, it is not
recommended. When an ozone system and the ACE system are used in