Manual

Installing Your WX 100 & 325 Series

Units Cartridges

WX 100 WXC01

WX 110 WXC11

WX 125 WXC11

WX325 WXC33

Never hook the system to the hot water line-

ONLY THE COLD

WX 100 inlet- off center

“ Outlet- center fitting

WX 325 inlet- rear fitting

“ outlet- front fitting

Turn off the cold water at the valve under the sink or nearest shut-off valve. Connect the

black tubing(inlet) to the water line or saddle valve (provided with the WX 125 & WX325

unit). Connect the clear tube(outlet) to the faucet or refrigerator connection. Note- DO NOT

turn inlet/outlet fittings on the head or manifold- these are sealed at the factory.

Activate the system and check for proper sealing at fittings. Turn your cold water

valve back on once the system is assembled. Flush the system by running atleast 5

gallons of water through it. Look for gray carbon dusting initially. This

carbon dusting

is harmless and will subside when the carbon has reached is proper absorption rate.

The dusting should go

away in a few days. Shut off the faucet after flushing and

check the seals.

Take the cartridge/s and push them up into the head/manifold. In the WX325, the

carbon cartridge is the blue tube with black

caps- the resin is the blue tube with white

caps.

Mounting the WateRx system: Measure the housing clearance (3 or more inches) and

affix the manifold to the wall of the undersink cabinet with drywall screws. The bracket

for the 100 series should go around the white sump, just below the upward curve.

Remove all packing materials from

the housing and cartridge inside.

Replacing the cartridge/s: Shut off the water valve nearest to the unit. Flip up the little

black handle on the faucet as if the water is continually running. This action releases the

pressure on the housin

and allows

ou to unthread the white sump from the head/manifold.

Remove cartridge/s and insert the new cartridges by pushing them up into the

head/manifold. Cover the new cartridges with the white sump/s and thread them onto the

black head/manifold. Turn your water back on.

Make sure to replace your cartridges annually.