Installation guide

WaterWorks ......... AUTOMATIC WATER CONDITIONER
PREMIER DEMAND TIMER FEATURES, SETTINGS, AND SERVICE, continued
setting: MODEL CODE, 12 OR 24 HOUR CLOCK, AND GALLONS OR LITERS MEASURE
NOTE: The model code is factory set at assembly and testing. The hour clock and water measure have factory
set default values. The defaults are: 12 or 24 hour clock - 12; Gallons or liters measure - gallons. The model
code should never require resetting, but to check, or to set if previously omitted, read below. The defaults suit
most installations. However, to make a change, read and do the following.
MODEL CODE: The timer must have the right mod-
el code set to operate the softener correctly. The
correct code setting is:
• For model WS 2000, it must show A-31.
is flashing in the display, do steps 3, 4, 6
To check for the correct code setting, and to reset
if needed, do steps 1, 2, 3, 4, 6 and 8.
12 OR 24 HOUR CLOCK: With 12 hr set, all time
displays are in standard clock time... 12:00AM to
11:59PM. If 24 hr is set, time displays are in military
time... 0100 (1:00AM) to 0000 (midnight). To change
from the 12 hr setting, do steps 1,2, 4, 5, 6 and 8.
GALLONS OR LITERS MEASURE: All water flow
rate and usage displays are in gallons with the de-
fault GALS setting. If reset to liters, the same dis-
plays are shown in liters. Use steps 1,2, 4, 6, 7 and
8 to change.
1. Beginning from the present time
display, press and hold in the SET
button until 2:00 AM (or as other-
wise set), and RECHARGE TiME
begin to flash.
2. Press and hold in the SET button
again. Either A- - - or a previously
set code will appear.
3. If setting is needed, use the SET
button, up or down arrow to set
A-31.
4. Press the SET button again, and
12 hr flashes along with TIME.
5. To change the display to 24 hr,
use the SET button, up arrow. Use
the down arrow to reset to 12 hr.
6. Press the SET button and GALS
flashes, along with GALLONS.
7. Use the SET button, up arrow to
change to the liter setting. Use the
down arrow to return to the gallon
setting.
8. Press the SET button a final time to return to the
present time display.
21