Installation guide

WaterWorks TM...... AUTOMATIC WATERCONDITIONER
PROGRAMMING THE PREMIER DEMAND TIMER, continued
• A "beeper" sounds while pressing buttons for timer programming. One beep signals a change in the timer
display. Repeated beeps means the timer will not accept a change from the button or arrow you have pressed,
and you should use another.
• To program the timer, you will use the SET button.
• SET PRESENT TIME OF DAY ................................................ .... .o..
NOTE: If the words PRESENT TIME do not show in the display, press the SET button until they do.
1. Press the SET button, up or down arrow to set.
The up arrow moves the display ahead; the down
arrow moves the time backward ........................
NOTE: Each press of a SET button arrow changes
the time by 1 minute. Holding the arrows in
changes the time 32 minutes each second.
If the present time is be-
tween noon and midnight,
be sure PM shows.
2. When the present time shows, press SETto ap-
ply.
If the present time is be- I
tween midnight and noon,
be sure AM shows.
• SET WATER HARDNESS NUMBER ..................................................
NOTE: If 25 (factory default) and HARDNESS do not show in the display, press the SET button until they do.
1. Press the SET button, up or down arrow to set
your water hardness number in the display. The
down arrow moves the display down to 1. The up ar-
row moves the display up to the maximum.
NOTE: Each press of a SET button arrow changes
the display by 1 between 1 and 25. Above 25, the
display changes 5 at a time ... 25, 30, 35, etc. Hold-
ing an arrow in changes the numbers twice each se-
cond.
2. When your water hardness number shows, press
SET to apply.
You can get the grains per
gallon (gpg) hardness of your
water supply from a water
analysis laboratory, or call and
ask your local water depart-
ment, if you are on a municipal
supply.
The special features of your timer are explained on pages 18 through 21.
TO COMPLETE THE INSTALLATION, DO THE SANITIZING PROCEDURES, PAGE 12.
11