USE & CARE GUIDE Waterwise 9000™ Countertop Steam Distiller See important safeguards on pages 2 and 3 An exclamation point within an equilateral triangle is intended to alert user to the presence of important operating and maintenance instructions in the literature accompanying the appliance. A lightning bolt within an equilateral triangle is intended to alert user to risk of injury from electric shock.
IMPORTANT SAFEGUARDS A person who has not read and understood all operating and safety instructions is not qualified to operate this appliance. When using this appliance, always adhere to basic safety precautions including: 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 2 READ ALL INSTRUCTIONS BEFORE USE. FOR HOUSEHOLD USE ONLY. Use INDOORS on a dry, level, well-supported, stable surface. DO NOT operate in a moving vehicle. DO NOT change position or location of Distiller while it is operating or cooling.
11. DO NOT operate without water in the boiler. Permanent damage may occur. 12. This Distiller requires no special care other than general cleaning (page 9) and periodic filter cup replacement (page 5). If servicing becomes necessary, contact an authorized dealer or authorized service facility. DO NOT attempt to repair Distiller yourself. There are NO user serviceable parts. See warranty for service details. 13. Unplug from wall outlet when not in use and before cleaning.
HOW IT WORKS Figure A This Distiller produces purified water by using the oldest, most effective method of water treatment—steam distillation. When the Distiller is operating, the water temperature rises to 212°F (100°C), killing bacteria, cysts, and viruses that may be present. As the boiling water (1) converts to steam (2), it rises and leaves behind dead microbes, dissolved solids, salts, heavy metals, and other substances.
PREPARING FOR FIRST TIME USE Clean Collector/Dispenser Bottle • • • • • • • Ensure the dispensing valve (fig. B) is installed and tightened. Fill bottle approximately three fourths full with warm tap water. Add one or two drops of dish detergent. DO NOT install filter cup at this time. Seal bottle opening with cap. Shake vigorously and drain. Rinse thoroughly. • • • • • • Add 6 ounces (180 ml) of 3 percent hydrogen peroxide to bottle. Fill with warm tap or distilled water (less than 120°F).
Clean Boiler • Remove boiler by grasping handle and pulling it out of chassis (fig. C). • Remove boiler cap by turning it counterclockwise (fig. D). • Loosen steam baffle securing nut by turning counterclockwise and remove steam baffle (fig. D). • Wash inside of boiler with soap and water. • Rinse thoroughly. Water should be drained through boiler spout. IMPORTANT: Wipe off all water deposits inside the Distiller chassis and on the outside of the boiler before each distillation cycle.
Figure D Spout Boiler Cap Steam Baffle Securing Nut Steam Baffle (flat side) Boiler Cap Gasket long end O-ring Flange Gasket Maximum Fill Point (bottom of tabs) Boiler 10. 11. 12. Slide boiler into chassis compartment and press firmly to ensure boiler is properly placed (fig. E). To prevent personal injury or property damage, the boiler must be fully engaged prior to start-up. Plug power cord into a properly rated, grounded outlet. Press “Start” button at base of boiler (fig. E).
Figure F Filter Cup Boiler Dispensing Valve Collector/Dispenser Bottle IMPORTANT: The collector/dispenser bottle must be properly placed, with its cap removed and filter cup in place, for proper water collection. DO NOT remove collector/dispenser bottle while Distiller is operating. NOTE: At the end of the distillation cycle (about 4.5 hours), Distiller will shut off automatically and “Start” light will go out. The fan will continue to operate for a few minutes. 15.
DISTILLER MAINTENANCE WARNING: Always be sure to unplug power cord from wall outlet before cleaning or servicing Distiller. Cleaning Boiler Rinse the boiler before every distillation cycle with warm tap water to remove any loose residue. Loosen securing nut and remove steam baffle (fig. D). Half fill boiler with warm tap water, agitate and discard the water. The water should be drained through boiler spout. Excessive deposits can cause malfunction.
TROUBLESHOOTING Problem Possible Cause Solution “Start” button does not light up. Distiller is not plugged in. Plug Distiller into appropriate outlet. Make sure the boiler is properly placed (fig. E). “Start” button lights up, but fan does not start. Fan delayed start system has not activated the fan. Wait about 30 minutes for the fan to start. Distiller does not operate. Distiller is not plugged in. Plug Distiller into appropriate outlet. Press “Start” button to restart.
PRACTICAL USES FOR CLEAN DISTILLED WATER Drinking… it’s healthy and delicious Complexion Care… daily cleansing without pore clogging impurities Cooking… enhances natural taste and appearance without unsavory chemicals Aquariums… fish thrive in a clean, clear, chlorine-free tank Houseplants… eliminate brown tips on foliage and salt deposits on flower pots— enjoy blooms longer Coffee, Tea & Cocoa… you’ll enjoy truer, richer flavors while using less Fruit Juices… experience the freshly squeezed, natural flavor
WARRANTY REGISTRATION CARD Please fill out and return the enclosed registration card or register online at http://www.waterwise.com/customers/customers.asp Registration will not affect warranty coverage, but may expedite processing of your warranty. Registration is the only way to guarantee you will be notified by Waterwise of any issues that arise concerning this product.
