Installation Guide

5
OPERATING YOUR NEW WHIRLPOOL
Before you turn your whirlpool on it should be filled with water two
inches above the highest jet. To turn the whirlpool on press the
round ON/OFF button installed on your tub. To turn the bath off press
the button again. If the pump does not start, either the GFCI is
tripped, there is no electrical power, or the tube to the motor is
disconnected at the air switch or motor.
For tubs that do not come with installed
buttons and controls, the installer must
mount all controls above water level on
a nearby surface.
THREE SPEED CONTROL
The three speed control button allows the bather to simultaneously
switch all jets from high to medium to low instead of individually adjusting
each jet’s pressure.
ADJUSTING YOUR TUB’S JETS
Your Watertech Whirlpool Bath comes equipped with high performance
spa jets that allow the bather complete control of water pressure and
direction. Rotating the jet’s circular face to the right increases the water
pressure and volume or to the left reduces the pressure and volume.
The direction of the water flow may be changed by moving the jet
eyeball up, down, left, or right to direct the water to the desired location.
JET CLEANING OR SERVICING
Each jet face is easily removed
from the inside of the tub for service
or cleaning. The jet face and the
pulsating face may be removed by
carefully prying away from the tub
with a thin spatula or putty knife.
Care should be taken not to
scratch the tub or jet. To avoid causing
leaks do not disturb the inner retainer.
OPTIONAL LOW WATER SENSOR CONTROL UNIT
The optional factory installed low water sensor
protects your whirlpool from running if there is
not enough water to operate safely. Should
your whirlpool fail to operate when filled to the proper depth be sure there is
electrical power available at the outlet. If power is available adjust the sensor by
filling your tub to the proper depth. Locate the sensor under your tub and slowly
turn the sensor adjustment screw until the indicator light turns on. Back the
screw slowly until the light goes off. Very slowly turn the screw until the light just
comes on again. Drain the tub water below the water level sensor. The light should