Installation & Assembly
VEN-038-WHEL Rev. C
B
C
D
A
1. 2. 3.
4.
HANDLE ON LEFT HANDLE IN FRONT HANDLE ON RIGHT
ORIGINAL FACTORY POSITION
MAY HIT BACKSPLASH
NEW ADJUSTED POSITION
CLEARS BACKSPLASH
H C
A
B
C D
A B E
E
G
C D F
F
ORIGINAL FACTORY POSITION
MAY HIT BACKSPLASH
NEW ADJUSTED POSITION
CLEARS BACKSPLASH
1. Place a small standard screwdriver in
the slot at the bottom
of metal ring that surrounds the handle caps (A). Gently pry
the cap from faucet handle (B).
2. Unscrew and remove holding screw (C) and washer (D).
3. Hold the handle (B) in a vertical position. Pull
straight o faucet. Rotate handle away from
backsplash then slide handle back onto valve
stem (E).
4. Insert holding screw with washer and
tighten. Snap handle cap back into place.
5. To adjust handle tension, turn ring (F)
clockwise to increase or counterclockwise to
decrease handle tension.
ADJUST HANDLE POSITION AND HANDLE TENSION
On some kitchen
countertops, the handle
may hit the backsplash
when the faucet handle
is positioned to the left or
right (Fig. 1). Waterstone
gives you the option of
adjusting the handle 45
degrees to avoid hitting
backsplash.
FIG.1
1. Gently unscrew and remove spray face (A) by hand.
2. To remove O-ring (B), aerator (C) and spray face insert (D), push with nger from bottom.
3. Thoroughly rinse aerator with water until all debris is removed.
4. Place spray face insert back into spray face and spin until it clicks into place. Next, place
aerator and O-ring into spray face. Gently screw spray face, by hand, snuggly back onto sprayer.
CLEANING AERATOR
A
B
1. Before connecting supply hoses, ush
supply stops to clear any debris. Place a
bucket underneath stops and run water for 5
to 10 seconds. Turn water o.
2. Carefully position hot and cold supplies so
they will not interfere with other hoses.
3. Connect supply hoses (A) to supply stops
(B). DO NOT use teon tape, plumbers tape or
plumbers putty.
Turn water back on and check for leaks.
CONNECTING SUPPLY HOSES
DEBRIS SCREEN FEATURE
B
C
A
1. Turn o water supplies underneath
sink and remove any water pressure
by opening the faucet handle.
2. Unscrew sprayer (A) from spray
hose by holding knurled swivel (B).
3. Inspect, remove and clean debris
screen (C) in sprayer. Once cleaned,
replace debris screen and reattach to
swivel.
4. Close faucet handle and turn on
water supplies. Make sure sprayer is
secure and sealed by running faucet.