Installation & Assembly
CLEANING DEBRIS SCREEN AND AERATOR - # 5300, 5400
A
C
B
SPRAYER
1. Turn o๎ water supplies underneath sink and remove any
water pressure by opening the faucet handle.
2. Unscrew sprayer (A) from spray hose by holding knurled
swivel (B).
3. Inspect, remove and clean debris screen (C) in sprayer. Once
cleaned, replace debris screen and reattach to swivel.
4. Close faucet handle and turn on water supplies. Make sure
sprayer is secure and sealed by
running faucet.
HANDLE ON LEFT HANDLE IN FRONT HANDLE ON RIGHT
ORIGINAL FACTORY POSITION
MAY HIT BACKSPLASH
NEW ADJUSTED POSITION
CLEARS BACKSPLASH
H C
A
B
C D
A B E
E
G
C D F
F
HANDLE ON LEFT HANDLE IN FRONT HANDLE ON RIGHT
ORIGINAL FACTORY POSITION
MAY HIT BACKSPLASH
NEW ADJUSTED POSITION
CLEARS BACKSPLASH
H C
A
B
C D
A B E
E
G
C D F
F
1. Unscrew and remove the metal cap (A). Remove Hot and Cold Indicator Ring (B).
2. Unscrew and remove holding screw (C) and washer (D).
3. Hold handle (E) in a vertical position. Pull straight o๎ faucet. Rotate handle
away from backsplash then slide handle back onto valve stem (F).
4. Insert holding screw with washer and tighten. Slide Hot and Cold Indicator
Ring onto handle and thread metal cap back into place.
5. To adjust handle tension, turn ring (G) clockwise to increase or
counterclockwise to decrease handle tension.
1. Place a small standard screwdriver in
the slot at the bottom of metal ring that surrounds the
handle caps (A). Gently pry the cap from faucet handle (B).
2. Unscrew and remove holding screw (C) and washer (D).
3. Hold the handle (B) in a vertical position. Pull straight o๎ faucet. Rotate handle away from
backsplash then slide handle back onto valve stem (E).
4. Insert holding screw with washer and tighten. Snap handle cap back into place.
5. To adjust handle tension, turn ring (F) clockwise to increase or counterclockwise to decrease
handle tension.
HOW TO ADJUST HANDLE POSITION AND HANDLE TENSION
CONTEMPORARY
TRADITIONAL
1. Gently unscrew and remove spout tip (A) by hand.
2. Remove O-ring (B). To remove aerator (C), push with ๎nger from bottom.
3. Thoroughly rinse aerator with water until all debris is removed.
4. Place aerator, then O-ring back into spout tip.
5. Gently screw spout tip, by hand, snuggly back onto spout.
On some kitchen countertops, the handle may
hit the backsplash when the faucet handle is
positioned to the left or right (Fig. 1). Waterstone
gives you the option of adjusting the handle 22
degrees to avoid hitting backsplash.
FIG.1
B
C
A
1. 3. 4.
2. 5.