Installation Guide

ManualsBrandsWATERSTONE ManualsSoap DispenserWATERSTONE 4055, 4055E, 4060, 4060E Soap/Lotion Dispenser

COUNTER

OR SINK

1-3/8”

HOLE

REQUIRED TOOLS:

Adjustable Wrench

3. 4.

6. 7. 8.

SOAP/LOTION DISPENSER INSTALLATION

TRADITIONAL Models # 4055, 4055E, 4060, 4060E

BEFORE YOU BEGIN YOUR INSTALLATION:

Pull and remove

spout (A) from

dispenser body

(B). Remove

clamp nut (C)

from threaded

shroud (D).

Fit dispenser body through 1-3/8”

hole on counter or sink. (No plumbers

putty is required. O-ring seals base).

Thread the clamp nut. Tighten nut

snug to underside of sink or counter.

Thread bottle (E) into bottom of

dispenser shroud.

Slide red tubing (F)

into tube tting (G)

at bottom of spout.

From above the

counter, pour

soap through

dispenser body

into plastic

bottle. Do not

overll.

Insert open end

of red tubing

down through

dispenser and

into plastic

bottle.

Pump spout a

few times to get

soap or lotion

owing.

41180 Raintree Court • Murrieta, CA 92562

1-888-304-0660 • 951-304-0520

www.waterstoneco.com

VEN-038-SOAP Rev. D

Push down on

spout to secure

over white O-rings.

Summary of content (1 pages)

PAGE 1
SOAP/LOTION DISPENSER INSTALLATION TRADITIONAL Models # 4055, 4055E, 4060, 4060E BEFORE YOU BEGIN YOUR INSTALLATION: REQUIRED TOOLS: Adjustable Wrench 1. 3. 2. 1-3/8” HOLE Pull and remove spout (A) from dispenser body (B). Remove clamp nut (C) from threaded shroud (D). A B 4. COUNTER OR SINK E D C 5. G Fit dispenser body through 1-3/8” hole on counter or sink. (No plumbers putty is required. O-ring seals base). Thread the clamp nut. Tighten nut snug to underside of sink or counter. 6. 7.