Installation Sheet
VEN-038-BARF 7-18
41180 Raintree Court • Murrieta, CA 92562
1-888-304-0660 • 951-304-0520 • www.waterstoneco.com
1. Before connecting supply hoses, ush supply stops to clear any debris. Place a bucket
underneath stops and run water for 5 to 10 seconds. Turn water o.
2. Carefully position hot and cold supplies so they will not interfere with other hoses.
3. Connect supply hoses (A) to supply stops (B). DO NOT use teon tape or plumbers putty.
Turn water back on and check for leaks.
CONNECTING SUPPLY HOSES
A
B
1. Gently unscrew and remove spout tip (A) by hand.
2. Remove O-ring (B). To remove aerator (C), push with nger from bottom.
3. Thoroughly rinse aerator with water until all debris is removed.
4. Place aerator, then O-ring back into spout tip.
5. Gently screw spout tip, by hand, snuggly back onto spout.
Depending on quality of your household water, the aerator
and debris screen may become clogged. We recommend
cleaning one week after installation, then a minimum of
once of year thereafter. To remove the debris, follow the
steps below.
CLEANING AERATOR AND DEBRIS SCREEN
B
C
A
1. 2. 3. 4. 5.