Installation Manual

Installation Quick Start Guide for WSW-4
Important Installation Instructions
1 Remove existing filter by turning the old filter one turn to the left
and remove from refrigerator.
2 Insert the new filter into the filter receptacle. Turn the filter a one
turn to the right so that it locks.
3 Run water from the dispenser for 5 minutes at .5 gpm (about 2½
gallons) to clear the system and any trapped air.
NOTE: Initial flow rate may be slower than expected.
Full flow rate should be restored within 24-36 hours.
4 Open the door to the refrigerator and check for leaks.
5 Place the six month replacement calendar label on the inside of
door.
For further questions or assistance please call [phone].
Warning: To reduce the risk of property damage from water leakage, the filter bypass plug MUST be used
when a filter replacement cartridge is not installed. For cold water applications only. Do not use with water that
is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.
Protect from freezing. REPLACE FILTER EVERY 6 MONTHS, OR IF BAD TASTE OR ODOR OCCUR
The risk associated with small parts can cause choking if swallowed.
Keep children away from small parts during the replacement of the water filter.
7/2016 • Rev #9 P/N 803016
TST Water, LLC, 42188 Rio Nedo, Temecula, CA
www.watersentinelfilters.com
Operating Temperature: 33°-100°F (0.6°-38°C)
Operating Pressure: 30-100 psi (207-689 kPa)
Life: 6 Months or 300 gallons (1,136 liters)
Specifications
This WSW-4 is Tested and
Certified by NSF International
against NSF/ANSI Standard
42 for the reduction of
chlorine taste and odor.
Component
This WSW-4 is Tested and
Certified by WQA against
NSF/ANSI Standard 42 for
the reduction of chlorine
taste and odor.