Installation Manual

Installation Quick Start Guide for WSW-2
Important Installation Instructions
1
Locate filter below the refrigerator. Slowly turn
the cartridge 1/4 turn counter-clockwise and
remove. Remove knob from old filter.
2
Remove all packaging, and remove the
protective cap from the top. Note installation
date on reminder sticker and place in a
conveninent visible location.
3
Slide knob from old filter onto new filter. Insert
filter into refrigerator and turn 1/4 turn
clockwise until firmly seated.
4
Run water for 3 minutes through the dispenser
to flush the filter.
NOTE: Initial flow rate may be slower than expected.
Full flow rate should be restored within 24-36 hours.
For further questions or assistance please call [phone].
Warning: To reduce the risk of property damage from water leakage, the filter bypass plug MUST be used
when a filter replacement cartridge is not installed. For cold water applications only. Do not use with water that
is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.
Protect from freezing. REPLACE FILTER EVERY 6 MONTHS, OR IF BAD TASTE OR ODOR OCCUR
The risk associated with small parts can cause choking if swallowed.
Keep children away from small parts during the replacement of the water filter.
7/2016 • Rev #9 P/N 803010
TST Water, LLC, 42188 Rio Nedo, Temecula, CA
www.watersentinelfilters.com
Operating Temperature: 33°-100°F (0.6°-38°C)
Operating Pressure: 30-100 psi (207-689 kPa)
Life: 6 Months or 300 gallons (1,136 liters)
Specifications
This WSW-2 is Tested and
Certified by NSF International
against NSF/ANSI Standard
42 for the reduction of
chlorine taste and odor.
Component
This WSW-2 is Tested and
Certified by WQA against
NSF/ANSI Standard 42 for
the reduction of chlorine
taste and odor.