Installation Manual

Installation Quick Start Guide for WSL-2
Important Installation Instructions
1 Locate existing filter and remove it by turning it
counter clockwise as shown in the graphic. The
filter will eject slightly with a clicking sound.
2 Holding new filter in your hands, carefully remove
the packaging and sanitary end-cap from the
new filter.
3 Insert the new filter into the refrigerator filter
receptacle. With the handle in the vertical
position, push the new filter into the housing until
it stops. When inserting the new filter, twist the
handle slightly left to right, while pushing inward.
Rotate the filter clockwise a full 1/4 turn until you
feel it stop. Ensure filter is fully installed in
refrigerator head a full 1/4 turn. This is required
to activate the internal valve inside the
refrigerator. If the filter is not turned a full 1/4
turn the valve will not fully open and may cause
the water flow to be slow, or even cause the
valve to make a chattering noise during use.
4 Run water from the dispenser for 5 minutes at .5
gpm (about 2½ gallons) to clear the system and
prevent sputtering.
NOTE: Initial flow rate may be slower than expected.
Full flow rate should be restored within 24-36 hours.
5 Reset your 'change filter' light
(if your fridge has one).
6 Check filter for any leaks. If leaks are detected,
uninstall and reinstall the filter as instructed
above.
For further questions or assistance please call [phone].
Warning: To reduce the risk of property damage from water leakage, the filter bypass plug MUST be used
when a filter replacement cartridge is not installed. For cold water applications only. Do not use with water that
is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.
Protect from freezing. REPLACE FILTER EVERY 6 MONTHS, OR IF BAD TASTE OR ODOR OCCUR
The risk associated with small parts can cause choking if swallowed.
Keep children away from small parts during the replacement of the water filter.
7/2016 • Rev #9 P/N 803044
TST Water, LLC, 42188 Rio Nedo, Temecula, CA
www.watersentinelfilters.com
Operating Temperature: 33°-100°F (0.6°-38°C)
Operating Pressure: 30-100 psi (207-689 kPa)
Life: 6 Months or 300 gallons (1,136 liters)
Specifications
This WSL-2 is Tested and
Certified by NSF International
against NSF/ANSI Standard
42 for the reduction of
chlorine taste and odor.
Component