Specifications

Waters Network Systems User’s Manual Page 10

PS-2126M-POE

3.4 Optional SFP Modules

The following lists the SFP modules that are available for this switch:

 SFP-1000SX-LC – multimode fiber transceiver with LC connector

 SFP-1000LX-LC-10 – singlemode (10km) fiber transceiver with LC connector

 SFP-1000LX-LC-30 – singlemode (30km) fiber transceiver with LC connector

3.5 Installation

Choose a surface for your switch that is clean, smooth and near a power outlet. Make sure that

there is enough clearance around the switch to allow attachment of cables, power cord and air

circulation.

1. Plug in the power cord into the switch.

2. Install the proper cable for network connection.

3. Plug the power cord into the power source.

3.6 Optional SFP Modules

The SFP modules are hot swappable, so you can plug or unplug the modules before and after

the switch is turned on. If you are installing the optional SFP fiber transceivers, follow these

guidelines:

1. Verify that the SFP module is the correct module and conforms to the chassis.

2. Slide the module along the slot.

3. Seat the module against the slot socket/connector.

4. Install the proper cable for network connection.

3.7 TP Port and Cable Installation

 Twisted pair port supports MDI/MDI-X auto-crossover, so both types of cable, straight-

through (Cable pin-outs for RJ-45 jack 1, 2, 3, 6 to 1, 2, 3, 6 in 10/100M TP; 1, 2, 3, 4, 5, 6, 7,

8 to 1, 2, 3, 5, 6, 7, 8 in Gigabit TP) and cross-over (Cable pin-outs for RJ-45 jack 1, 2, 3, 6

to 3, 6, 1, 2) can be used.

 Use CAT5 grade RJ45 TP cable to connect to a TP port of the switch to a network-aware

device such as a workstation or a server.

 Repeat the above steps for each RJ45 port to be connected to a Gigabit 10/100/1000 TP

device.

3.8 Power On

The switch supports 100-240 VAC, 50-60 Hz power supply. The power supply will automatically

convert the local AC power source to DC power. Power can be turned on even if there are no

connections to the switch ports. Once the power is on, LEDs will light up and then go out

except the power LED.