Specifications

LAN Configuration
90
ProSAFE Gigabit Quad WAN SSL VPN Firewall SRX5308
Port Membership
Port 1, Port 2, Port 3,
Port 4 / DMZ
Select one, several, or all port check boxes to make the ports members of this
VLAN.
Note: A port that is defined as a member of a VLAN profile can send and receive
data frames that are tagged with the VLAN ID.
IP Setup
IP Address Enter the IP address of the VPN firewall (the factory default address is
192.168.1.1).
Note: Ensure that the LAN port IP address and DMZ port IP address are in
different subnets.
Note: If you change the LAN IP address of the VLAN while being connected
through the browser to the VLAN, you are disconnected. You then need to open
a new connection to the new IP address and log in again. For example, if you
change the default IP address 192.168.1.1 to 10.0.0.1, you now need to enter
https://10.0.0.1 in your browser to reconnect to the web management interface.
Subnet
Mask Enter the IP subnet mask.
The subnet mask specifies the network number portion
of an IP address. Based on the IP address that you assign, the VPN firewall
automatically calculates the subnet mask. Unless you are implementing
subnetting, use 255.255.255.0 as the subnet mask (computed by the VPN
firewall).
DHCP
Disable DHCP Server If another device on your network is the DHCP server for the VLAN, or if you
intend to manually configure the network settings of all of your computers, select
the Disable DHCP Server radio button to disable the DHCP server. Except for
the default VLAN for which the DHCP server is enabled, this is the default setting.
Table 16. Add VLAN Profile screen settings (continued)
Setting Description