Specifications

IPv4 and IPv6 Internet and WAN Settings

ProSAFE Gigabit Quad WAN SSL VPN Firewall SRX5308

• Hosts. The IP address, IP addresses, or group to which the rate control profile

applies. (The information in this column does not apply to priority profiles).

• Action. The Edit table button provides access to the Edit QoS screen for the

corresponding profile.

 To add a rate control QoS profile:

1. Select Network Configuration > QoS. The QoS

screen displays.

2. Under the List of QoS Profiles table, click the Add table button. The

Add QoS screen

displays. The following figure shows settings for a rate control QoS profile:

Figure 48.

3. Enter the settings as described in the following table:

Table 14. Add QoS screen settings for a rate control profile

Setting Description

QoS Type Rate Control (for Priority, see Figure 49 on page 80 and T

able 15 on page 80).

Interface From the drop-down list, select one of the WAN interfaces.

Service From the drop-down list, select a service or application to be covered by this

profile. If the service or application does not appear in the list, you need to

define it using the Services screen (see Add Customized Services on

page 177).

Direction From the drop-down list, select the direction to which rate control is applied:

• Inbound T

raffic. Rate control is applied to inbound traf

fic only.

• Outbound Traffic. Rate control is applied to outbound traf

fic only.

• Both. Rate control is applied to both outbound and inbound traffic.