Specifications

IPv4 and IPv6 Internet and WAN Settings

ProSAFE Gigabit Quad WAN SSL VPN Firewall SRX5308

Note: To configure and apply QoS profiles successfully, familiarity with

QoS concepts such QoS priority queues, IP precedence, DHCP, and

their values is helpful.

 To enable and configure QoS for the WAN interfaces:

1. Select Network Configuration > QoS. The QoS

screen displays. (The following screen

shows some profiles in the List of QoS Profiles table).

Figure 47.

2. To enable QoS, select the Yes radio button. By default, the No radio button is selected.

3. Specify the profile type that should be active by selecting one of the following radio buttons:

• Rate control. All rate control QoS profiles that you configure are active, but priority

QoS profiles are not.

• Priority. All priority QoS profiles that you configure are active, but rate control QoS

profiles are not.

4. Click Apply

to save your settings.

The List of QoS Profiles table shows the following columns, all of which are described in

detail in the following table and Table 15 on page 80.

• QoS Type. The type of profile, either Rate Control or Priority.

• Interface Name

. The W

AN interface to which the profile applies (WAN1, WAN2,

WAN3, or WAN4).

• Service. The service to which the profile applies.

• Direction

. The W

AN direction to which the profile applies (inbound, outbound, or

both).

• Rate. The bandwidth rate in Kbps, or the priority.