Specifications

IPv4 and IPv6 Internet and WAN Settings
60
ProSAFE Gigabit Quad WAN SSL VPN Firewall SRX5308
6. Click Apply to save your changes.
7. Verify the connection:
a. Select
Network Configuration > WAN Settings > W
AN Setup.
b. In the upper right of the screen, select the IPv6 radio button. The WAN Setup screen
displays the IPv6 settings (see
Figure 32 on page 58).
c. In the Action column, click the Status
button of the WAN interface for which you
want to display the Connection Status pop-up screen. (The following figure shows a
static IP address configuration; the IP addresses are not related to any other
examples in this manual.)
Figure 34.
The Connection Status screen should show a valid IP address and gateway, and you are
connected to the Internet. If the configuration was not successful, see Troubleshoot the
ISP Connection on page 396.
Note: For more information about the Connection Status screen, see View
the WAN Port Status on page 382.
Note: If your ISP requires MAC authentication and another MAC address
has been previously registered with your ISP, you need to enter that
address on the WAN Advanced Options screen for the
corresponding WAN interface (see Configure Advanced WAN
Options and Other Tasks on page 71).