Specifications

IPv4 and IPv6 Internet and WAN Settings
46
ProSAFE Gigabit Quad WAN SSL VPN Firewall SRX5308
2. In the Load Balancing Settings section of the screen, configure the following settings:
a. Select the Primary WAN Mode
radio button.
b. From the corresponding drop-down list on the right, select a WAN interface to
function as the primary W
AN interface. The other WAN interfaces become disabled.
c. Select the Auto Rollover check box.
d. From the corresponding drop-down list on the right, select a W
AN interface to
function as the backup W
AN interface.
Note: Ensure that the backup WAN interface is configured before enabling
auto-rollover mode.
3. Click Apply to save your settings.
Configure the Failure Detection Method for IPv4 Interfaces
 To configure the failure detection method:
1. Select Network Configuration > WAN Settings > W
AN Setup. In the upper right of the
screen, the IPv4 radio button is selected by default. The WAN Setup screen displays the
IPv4 settings (see Figure 11 on page 31).
2. Click the Edit table button in the Action column of the W
AN interface that you selected as
the primary WAN interface. The WAN IPv4 ISP Settings screen displays (see Figure 12 on
page 32, which shows the WAN2 IPv4 ISP Settings screen as an example).
3. Click the Advanced option arrow in the upper right of the screen. The W
AN Advanced
Options screen displays for the WAN interface that you selected. (For an image of the entire
screen, see Figure 46 on page 73).
4. Locate the Failure Detection Method section on the screen. Enter the settings as described
in the following table.
Figure 24.