Specifications

Default Settings and Technical Specifications
405
ProSAFE Gigabit Quad WAN SSL VPN Firewall SRX5308
Factory Default Settings
You can use the factory default Reset button on the rear panel to reset all settings to their
factory defaults. This is called a hard reset (for more information, see Revert to Factory
Default Settings on page 349):
• To perform a hard reset, press and hold the factory default Reset button for approximately
8 seconds (until the
Test LED blinks rapidly). The VPN firewall returns to the factory
configuration settings that are shown in the following table.
• Pressing the factory default Reset button for a shorter period causes the VPN firewall to
reboot.
The following table shows the default configuration settings for the VPN firewall:
Table 100. VPN firewall factory default configuration settings
Feature Default Behavior
Login settings
User login URL https://192.168.1.1
Administrator user name (case-sensitive) admin
Administrator login password (case-sensitive) password
Guest user name (case-sensitive)
guest
Guest login password (case-sensitive) password
WAN settings
WAN IPv4 mode (all WAN interfaces) NAT
W
AN IPv4 load balancing settings (all W
AN interfaces) Primary WAN mode
WAN IPv6 mode (all WAN interfaces) IPv4 only mode
Stateless IP/ICMP Translation (SIIT) Disabled
WAN MAC address (all WAN interfaces) Use default MAC addresses of the
VPN firewall.
WAN MTU size (all WAN interfaces) 1500 bytes
1492 bytes for PPPoE connections
Port speed (all WAN interfaces) AutoSense
Secondary IPv4 WAN addresses None
Dynamic DNS for IPv4 Disabled
WAN QoS profiles for IPv4 None