Specifications

IPv4 and IPv6 Internet and WAN Settings
39
ProSAFE Gigabit Quad WAN SSL VPN Firewall SRX5308
9. Click Apply to save your changes.
10. Click Test to evaluate your entries. The VPN firewall attempts to make a connection
according to the settings that you entered.
11. Verify the connection:
a. Select
Network Configuration > WAN Settings > W
AN Setup. The WAN Setup
screen displays the IPv4 settings (see Figure 14 on page 34).
b. In the Action column, click the Status
button of the WAN interface for which you
want to display the Connection Status pop-up screen. (The following figure shows a
PPPoE configuration; the IP addresses are not related to any other examples in this
manual.)
Figure 19.
The Connection Status screen should show a valid IP address and gateway, and you are
connected to the Internet. If the configuration was not successful, see Troubleshoot the
ISP Connection on page 396.
Table 5. DNS server settings
Setting Description
Get Automatically
from ISP
If your ISP has not assigned any Domain Name Server (DNS) addresses, select the
Get Automatically from ISP radio button.
Use These
DNS
Servers
If your ISP has assigned DNS addresses, select the Use These DNS Servers radio
button. Make sure that you fill in valid DNS server IP addresses in the fields. Incorrect
DNS entries might cause connectivity issues.
Primary DNS Server The IP address of the primary DNS server.
Secondary DNS Server The IP address of the secondary DNS server.