Specifications

Monitor System Access and Performance
358
ProSAFE Gigabit Quad WAN SSL VPN Firewall SRX5308
3. Click Apply to save your settings.
4. If you want to enable the traffic meter for another W
AN interface, click the associated WAN
Traffic Meter tab for that interface, and repeat Step 2 and Step 3 for that WAN interface.
The contents of the WAN2 Traffic Meter, WAN3 Traffic Meter, and WAN4 Traffic Meter
screens are identical to the WAN1
Traffic Meter screen except for the WAN interface number.
To display a report of the Internet traffic by type for a WAN interface, click the Traffic by
Protocol option arrow in the upper right of the associated WAN Traffic Meter screen. The
Traffic by Protocol pop-up screen displays. The incoming and outgoing volume of traffic for
each protocol and the total volume of traffic are displayed. Traffic counters are updated in
MBs; the counter starts only when traffic passed is at least 1 MB. In addition, the pop-up
screen displays the traffic meter’s start and end dates. If you did not configure the traffic
meter, the start date is blank.
Figure 228.
When Limit is reached
Block Traffic Select one of the following radio buttons to specify which action the VPN firewall
performs when the traffic limit has been reached:
• Block All
T
raffic. All incoming and outgoing Internet and email traffic is
blocked.
• Block All
T
raffic Except E-Mail. All incoming and outgoing Internet traffic is
blocked, but incoming and outgoing email traffic is still allowed.
Send e-mail alert An email alert is sent when traffic is blocked. Ensure that emailing of logs is enabled
on the Firewall Logs & E-mail screen (see Configure Logging, Alerts, and Event
Notifications on page 362).
Table 88. WAN1 Traffic Meter screen settings (continued)
Setting Description