Specifications

Monitor System Access and Performance
357
ProSAFE Gigabit Quad WAN SSL VPN Firewall SRX5308
Table 88. WAN1 Traffic Meter screen settings
Setting Description
Enable Traffic Meter
Do you want to
enable Traf
fic
Metering on WAN1?
Select one of the following radio buttons to configure traffic metering:
• Yes.
Traffic metering is enabled, and the traffic meter records the volume of
Internet traffic passing through the WAN interface. Complete the fields that are
shown on the right side of the screen (see explanations later in this table).
• No.
Traffic metering is disabled. This is the default setting.
Select one of the following radio buttons to specify if or how the VPN firewall applies
restrictions when the traffic limit is reached:
• No Limit
. No restrictions are applied when the traf
fic limit is reached.
• Download only. Restrictions are applied to incoming traffic when the traf
fic limit
is reached. Fill in the Monthly Limit field.
• Both Directions. Restrictions are applied to both incoming and outgoing traf
fic
when the traf
fic limit is reached. Fill in the Monthly Limit field.
Monthly Limit Enter the monthly traffic volume limit in MB. The default setting is 0
MB.
Increase this
month limit by
Select this check box to temporarily increase a previously specified
monthly traf
fic volume limit, and enter the additional allowed volume
in MB.
The default setting is 0 MB.
Note: When you click Apply to save these settings, this field is reset
to 0 MB so that the increase is applied only once.
This month
limit
This is a nonconfigurable field that displays the total monthly traffic
volume limit that applies to this month. This total is the sum of the
monthly traffic volume and the increased traffic volume.
Traffic Counter
Restart Traffic
Counter
Select one of the following radio buttons to specify when the traf
fic counter restarts:
• Restart Traffic Counter Now. Select this option, and click Apply
at the bottom
of the screen to restart the traffic counter immediately.
• Restart T
raffic Counter at a Specific T
ime. Restart the traffic counter at a
specific time and day of the month. Fill in the time fields, and select AM or PM
and the day of the month from the drop-down lists.
Send e-mail report
before restarting
counter
An email report is sent immediately before the counter restarts. Ensure that emailing
of logs is enabled on the Firewall Logs & E-mail screen (see Configure Logging,
Alerts, and Event Notifications on page 362).