Specifications

Network and System Management
349
ProSAFE Gigabit Quad WAN SSL VPN Firewall SRX5308
Restore Settings
WARNING:
Restore only settings that were backed up from the same software
version. Restoring settings from a different software version can
corrupt your backup file or the VPN firewall system software.
 To restore settings from a backup file:
1. On the Settings Backup and Firmware Upgrade screen (see Figure 225 on page 348),
next to Restore saved settings from file, click Browse.
2. Locate and select the previously saved backup file (by default, SRX5308.cfg)
.
3. After you have selected the file, click the Restore button. A warning message might display
,
and you might have to confirm that you want to restore the configuration.
The VPN firewall reboots. During the reboot process, the Settings Backup and Firmware
Upgrade screen might remain visible, or a status message with a counter might show the
number of seconds left until the reboot process is complete. The reboot process takes about
160 seconds. (If you can see the unit:
The reboot process is complete when the Test LED on
the front panel goes off.)
WARNING:
Once you start restoring settings, do not interrupt the process. Do
not try to go online, turn off the VPN firewall, shut down the
computer, or do anything else to the VPN firewall until the settings
have been fully restored.
Revert to Factory Default Settings
 To reset the VPN firewall to the original factory defaults settings:
Use one of the following two methods:
• Using a sharp object, press and hold the factory default Reset button on the rear panel of
the VPN firewall (see Rear Panel on page 19) for about 8 seconds until the Test LED
turns on and begins to blink (about 30 seconds). To restore the factory default settings
when you do not know the administration password or IP address, you need to use the
factory default Reset button method.
• On the Settings Backup and Firmware Upgrade screen (see the Figure 225 on
page 348), next to Revert to factory defaults settings, click the Default button, and
confirm your selection.
The VPN firewall reboots. If you use the software Default button, the Settings Backup and
Firmware Upgrade screen might remain visible during the reboot process, or a status
message with a counter might show the number of seconds left until the reboot process is
complete.
The reboot process takes about 160 seconds. (If you can see the unit:
The reboot
process is complete when the Test LED on the front panel goes off.)