Specifications

Virtual Private Networking Using IPSec and L2TP Connections
270
ProSAFE Gigabit Quad WAN SSL VPN Firewall SRX5308
 To enable the PPTP server and configure the PPTP server pool, authentication, and
encryption:
1. Select VPN > PPTP Server. The PPTP Server screen displays. (The following figure
contains an example.)
Figure 179.
2. Enter the settings as described in the following table:
Table 66. PPTP Server screen settings
Setting Description
PPTP Server
Enable To enable the PPTP server, select the Enable check box.
Start IP Address
Type the first IP address of the address pool.
End IP Address Type the last IP address of the address pool. A maximum of 26 contiguous
addresses can be part of the pool. (The first address of the pool cannot be
assigned to a user.)
User time out Enter the time-out period in seconds, from 0 to 999 seconds. The default is
0 seconds. If there is no traffic from a user, the connection is disconnected after
the specified period.
Authentication
Select one or more of the following authentication methods to authenticate PPTP users:
• PA
P. RADIUS-Password
Authentication Protocol (PAP).
• CHAP. RADIUS-Challenge Handshake Authentication Protocol (CHAP).
• MSCHAP
. RADIUS-Microsoft CHAP (MSCHAP).
• MSCHAPv2. RADIUS-Microsoft CHAP version 2 (MSCHAPv2).