Specifications

Introduction
19
ProSAFE Gigabit Quad WAN SSL VPN Firewall SRX5308
Rear Panel
The rear panel of the VPN firewall includes a console port, a Factory Defaults Reset button, a
cable lock receptacle, an AC power connection, and a power switch.
Figure 2.
Viewed from left to right, the rear panel contains the following components:
• Cable security lock receptacle.
• Console port. Port for connecting to an optional console terminal.
The port has a DB9
male connector
. The default baud rate is 115200 K. The pinouts are (2) Tx, (3) Rx, (5) and
(7) Gnd. For information about accessing the command-line interface (CLI) using the
console port, see Use the Command-Line Interface on page 342.
DMZ LED On (green) Port 4 operates as a dedicated hardware DMZ port.
Off Port 4 operates as a normal LAN port.
WAN Ports
Left LED On (green) The WAN port has a valid connection with a device that provides an
Internet connection.
Blinking (green) The WAN port receives or transmits data.
Off The WAN port has no physical link, that is, no Ethernet cable is plugged
into the VPN firewall.
Right LED On (green) The WAN port operates at 1000 Mbps.
On (amber) The WAN port operates at 100 Mbps.
Off The WAN port operates at 10 Mbps.
Internet LED On (green) The WAN port has a valid Internet connection.
Off The WAN port is either not enabled or has no link to the Internet.
Table 1. LED descriptions (continued)
LED Activity Description
Security lock
receptacle
Console port
Factory Defaults
AC power
receptacle
Power
switch
Reset button