Specifications

Firewall Protection
160
ProSAFE Gigabit Quad WAN SSL VPN Firewall SRX5308
2. Click one of the following table buttons:
• Enable. Enables the rule or rules. The ! status icon changes from a gray circle to a
green circle, indicating that the selected rule or rules are enabled. (By default, when a
rule is added to the table, it is automatically enabled.)
• Disable
. Disables the rule or rules. The ! status icon changes from a green circle to a
gray circle, indicating that the selected rule or rules are disabled.
• Delete
. Deletes the selected rule or rules.
Create LAN DMZ Outbound Service Rules
You can change the default outbound policy or define rules that specify exceptions to the
default outbound policy. By adding custom rules, you can block or allow access based on the
service or application, source or destination IP addresses, and time of day. An outbound rule
can block or allow traffic between the DMZ and any internal LAN IP address according to the
schedule created on the Schedule screen.
IPv4 LAN DMZ Outbound Service Rules
 To create an IPv4 LAN DMZ outbound rule:
1. In the upper right of the LAN DMZ Rules screen, the IPv4 radio button is selected by default.
The screen displays the IPv4 settings (see Figure 87 on page 158).
Click the Add table button under the Outbound Services table. The
Add LAN DMZ
Outbound Service screen for IPv4 displays:
Figure 89.
2. Enter the settings as described in Table 33 on page 137. In addition to selections from the
Service, Action, and Log drop-down lists, you need to make selections from the following
drop-down lists:
• LAN Users
• DMZ Users