Specifications

Firewall Protection
156
ProSAFE Gigabit Quad WAN SSL VPN Firewall SRX5308
Unless your selection from the Action drop-down list is BLOCK always, you also need to
make selections from the following drop-down lists:
• Select Schedule
• QoS Priority
4. Click Apply. The new rule is now added to the Outbound Services table.
The rule is
automatically enabled.
Create DMZ WAN Inbound Service Rules
The Inbound Services table lists all existing rules for inbound traffic. If you have not defined
any rules, no rules are listed. By default, all inbound traffic (from the Internet to the DMZ) is
blocked.
Inbound rules that are configured on the LAN WAN Rules screen take precedence over
inbound rules that are configured on the DMZ WAN Rules screen.
As a result, if an inbound
packet matches an inbound rule on the LAN WAN Rules screen, it is not matched against the
inbound rules on the DMZ WAN Rules screen.
IPv4 DMZ WAN Inbound Service Rules
 To create an IPv4 DMZ WAN inbound rule:
1. In the upper right of the DMZ WAN Rules screen, the IPv4 radio button is selected by
default. The
screen displays the IPv4 settings (see Figure 81 on page 152).
Click the Add table button under the Inbound Services table. The
Add DMZ WAN
Inbound Service screen for IPv4 displays:
Figure 85.