Specifications

Firewall Protection
155
ProSAFE Gigabit Quad WAN SSL VPN Firewall SRX5308
2. Enter the settings as described in Table 33 on page 137. In addition to selections from the
Service, Action, and Log drop-down lists, you need to make selections from the following
drop-down lists:
• DMZ Users
• WAN Users
Unless your selection from the Action drop-down list is BLOCK always, you also need to
make selections from the
following drop-down lists:
• Select Schedule
• NAT IP (This drop-down list is available only when the WAN mode is NAT.)
The following configuration is optional:
• QoS Profile
3. Click Apply.
The new rule is now added to the Outbound Services table.
The rule is
automatically enabled.
IPv6 DMZ WAN Outbound Service Rules
 To create an IPv6 DMZ WAN outbound rule:
1. In the upper right of the DMZ WAN Rules screen, select the IPv6 radio button.
The screen
displays the IPv6 settings (see Figure 82 on page 153).
2. Click the Add table button under the Outbound Services table. The
Add DMZ WAN
Outbound Service screen for IPv6 displays:
Figure 84.
3. Enter the settings as described in Table 33 on page 137. In addition to selections from the
Service, Action, and Log drop-down lists, you need to make selections from the following
drop-down lists:
• DMZ Users
• WAN Users