Specifications

Firewall Protection
142
ProSAFE Gigabit Quad WAN SSL VPN Firewall SRX5308
Send to LAN Server The LAN server address determines which computer on your
network is hosting this service rule. (You can also translate this
address to a port number.) The options are:
• Single address. Enter the required address in the Start field
to apply the rule to a single device on your LAN.
• Address range. Enter the required addresses in the Start
and Finish fields to apply the rule to a range of devices.
IPv4 LAN WAN rules
Send to DMZ Server
The DMZ server address determines which computer on your
network is hosting this service rule. (Y
ou can also translate this
address to a port number.)
IPv4 DMZ WAN rules
Translate to Port
Number
If the LAN server or DMZ server that is hosting the service is
using a port other than the default port for the service, you can
select this setting and specify a port number. If the service is
using the default port, you do not need to select this setting.
IPv4 LAN WAN rules
IPv4 DMZ WAN rules
WAN Destination IP
Address
The setting that determines the destination IP address applicable
to incoming traffic. This is the public IP address that maps to the
internal LAN server.
This can be either the address of the WAN interface or another
public IP address.
You can also enter an address range. Enter the required
addresses in the Start and Finish fields to apply the rule to a
range of devices.
IPv4 LAN WAN rules
IPv4 DMZ WAN rules
LAN Users These settings apply to a LAN WAN inbound rule when the WAN
mode is classical routing, and determine which computers on
your network are affected by this rule. The options are:
• Any.
All computers and devices on your LAN.
• Single address. Enter the required address in the Start field
to apply the rule to a single device on your LAN.
• Address range. Enter the required addresses in the Start
and Finish fields to apply the rule to a range of devices.
• Group
. Select the LAN group to which the rule applies. Use
the LAN Groups screen to assign computers to groups (see
Manage the Network Database on page 97). Groups apply
only to IPv4 rules.
• IP Group. Select the IP group to which the rule applies. Use
the IP Groups screen to assign IP addresses to groups. See
Create IP Groups on page 179.
Note: For IPv4 LAN WAN inbound rules, this field does not
apply when the WAN mode is NAT because your network
presents only one IP address to the Internet.
LAN WAN rules
LAN DMZ rules
Table 34. Inbound rules overview (continued)
Setting Description Inbound Rules