Installation guide

WATERS NETWORK SYSTEMS™ ProSwitch
®
- 2600M, User’s Manual, 02/07 Page 49
6.21 Maintenance Tools
The following four functions are supported in the system maintenance tools:
 System Reset – resets the switch.
 System Restore – restores switch configuration to the factory default settings.
 System Backup/Restore – Backup will make a backup copy of the configuration.
Restore will import the backup configuration and restore it to the switch.
 System Upgrade – use this function to upgrade the system software.
6.24 – Maintenance Tools
6.22 Telnet and SNMP
In order to use Telnet to manage the switch from a remote site, the IP/Mask/Gateway must
be set. Once the address is set, use the Telnet command from the DOS window of your
workstation. The operation from the Telnet access is the same as the console interface.
The same settings must be configured in order to manage the switch with an SNMP
management program. SNMP must be configured either from the console connection or
the web interface before you can use SNMP to manage the switch.
This switch supports SNMP Version 1 agent function and MIB II(Interface), Bridge MIB,
Etherlike MIB and Private MIB. The default GET community name is public and SET
community name is private. The switch supports up to five trap receivers with different trap
community names.