Installation guide

WATERS NETWORK SYSTEMS™ ProSwitch
®
- 2600M, User’s Manual, 02/07 Page 47
6.18 SNMP
Use this option to configure the SNMP settings. Once SNMP has been configured, you will
be able to manage the switch from an SNMP management program.
1. In the RMON section of the screen choose enable or disable. RMON is disabled by
default.
2. Click Apply
3. Enter the System Information.
4. Click Apply
5. Enter the following information:
• GET/SET Community Name
• Trap IP Address and Community Name
6. Click Apply to save the settings.
6.21 – SNMP Settings