Installation guide

WATERS NETWORK SYSTEMS™ ProSwitch
®
- 2600M, User’s Manual, 02/07 Page 43
6.14 Mirror Settings
To configure the Mirror function, follow these steps:
1. Select Enable in Mirroring.
2. Click Apply to enable the function.
3. Select the capture port. The monitored traffic will be forwarded to this port.
4. Select the monitored port from Ingress or Egress table – depending on the traffic
direction.
5. Select the filter mode. Choose between All packets or DA/SA address. If DA/SA is
selected, enter the special MAC address in the xx-xx-xx-xx-xx-xx format.
6. Enter the capture frequency.
7. Click Apply to save the settings.
8. If you want to disable the Mirror function, select Disable and click Apply.
6.17 – Mirror Settings